Orders Only: 1-800-723-5937 Information: 1-406-259-9004
Hours: Mon - Sat 10-6 MST
Central Hobbies
1401 Central Avenue
Billings, MT 59102
We Gladly Accept:
as well as
PLASTIC MODELS : AIRPLANES / HELICOPTERS
Shipping cost will vary by dimensions
or weight please call or email for shipping quotes.
- Page 12 of 13 | 151 Total Products
REVELL 1/48 TOPGUN Maverick’s F/A-18E Super Hornet
Description:
Parts: 161
Our Price: $30.95
Boeing 707-120 1/139 Airliner Plastic Model Kit Atlantis
Description:
Our Price: $19.99
TAMIYA 1/48 Mitsubishi A6M3/3A (Zeke)
Description:
Following the Zero Model 21 (A6M2), which achieved overwhelming victories against Allied forces in the first half of Pacific War, the summer 1942 saw the introduction of the Model 32 (A6M3) which was powered by a Sakae 21 engine and an 11m wingspan with clipped wingtips. Although top speed increased, its range reduced drastically, therefore the Model 22 (A6M3) was rushed into development in order to correct the Model 32's shortcomings. Overall performance improved as the 12m wingspan and folding wingtips were reintroduced to regain maneuverability and new wing fuel tanks restored range to 2,560km. The Model 22 (A6M3a) which was fitted with long-barreled cannons was also put into production. Deployed mainly to the Solomon Islands from early 1943, Zeroes had fierce battles against U.S. fighters.
★1/48 scale plastic assembly model kit of the Mitsubishi A6M3 Model 22 Zero.
★Length: 190mm, Wingspan: 250mm
★Well-balanced form of the aircraft has been beautifully reproduced.
★Photo-etched parts depict the folded wingtip mechanism
★The A6M3a which was armed with long-barreled cannons can also be assembled.
★You can choose to assemble the cowl flap in either open or closed position. Also, flaps can be depicted in either up or down positions.
★1 seated and 4 standing pilot figures included.
★Comes with 3 kinds of markings including one to depict the aircraft from the 251st Naval Air Group.
Our Price: $51.99
FIELD OF VALOR 1/72 F4U-1D Corsair
Description:
Our Price: $10.99
F3H-2 DEMON
Description:
The McDonnell F3H Demon is a subsonic swept-wing carrier-based jet fighter aircraft designed and produced by the American manufacturer McDonnell Aircraft Corporation. It was the first swept wing jet fighter and the only single-engined carrier-based fighter the company produced.
The F3H-2 was the single-seat strike fighter version, retaining Sidewinder and Sparrow capability of the −2M/N and adding payload of 6,000 lb (2,730 kg) bombs or rockets. 239 built. The U.S. Navy placed an order for 239 F3H-2s, the first of which being deployed during March 1956. In 1962, the F3H-2 designation changed to F-3B. During September 1964, the final Demon-equipped squadron, VF-161 'Chargers', traded their F-3s for F-4 Phantom IIs.
- Scale: 1/48
- Length: 15.15" (385mm)
- Wingspan: 8.74" (222.2mm)
Our Price: $58.45
HOBBY BOSS 1/48 A-10A “THUNDERBOLT” II
Description:
The A-10 is a high -survivability and versatile aircraft, popular with pilots for the 'get home' effectiveness. The mission of the aircraft is ground attack against tanks, armoured vehicles and installations, and close air support of ground forces. The aircraft is suitable for eperation from forward air bases, with short take-off and landing capability. The aircraft has a long range (800 miles) and endurance and can loiter in the battle area. The manoeuvrability at low speed and at low altitude (below 1,000ft) allows accurate and effective targeting and weapon delivery over all types of terrain. The first flight of the A-10 was in May 1972, and a total of 715 aircraft have since been produced. Originally manufactured by Fairchild, since 1987 the prime contractor for the A-10 has been Northrop Grumman, Which carries out support and structural upgrade programmes from the Integrated Systems and Aerostructures Divisions at New York and at St Augustine in Florida. Over 350 A-10 aircraft are in service with the US Air Force, and the Air National Guard.
Length: 338.7mm
Width: 366.0mm
Total Parts 298pcs
Our Price: $53.99
REVELL 1/48 F-22 Raptor
Description:
The production F-22 was delivered in January of 2003. Originally designed as an air superiority fighter, the F-22 has expanded to the role of a ground attack aircraft. All of the F-22 attack weapons are stored internally which helps it to avoid radar detection. In addition the F-22 has vectored thrusters which give it the ability to virtually fly straight up from a stationary position.
• Full complement of on-board weapons with four separate open weapon storage compartments
• Positional rear thrust deflectors and horizontal stabilizers
• Decal with graphics for all the current F-22 squadron commanders aircraft.
• Molded in light gray and transparent yellow
Skill Level: 5
Scale: 1/48
Wingspan: 7.375"
Length: 10.5"
Height: 2.75
Parts: 118
Our Price: $25.95
TAMIYA 1/72 F-35B Lightning Ii
Description:
This model kit faithfully recreates the bleeding edge airframe of the F-35B Lightning II. The F-35 Lightning II is a state-of-the-art multirole stealth fighter developed by Lockheed Martin for the U.S. military and selected allies. The fighter has three variants: the multi-role fighter F-35A, the short take-off and vertical landing (STOVL) F-35B, and the carrier-capable F-35C. This 1/72 scale model was manufactured by Italeri in 2019 and now joins the Tamiya 1/72 scale War Bird Series with the addition of Tamiya materials and parts.
• 1/72 scale plastic model assembly kit.
• New packaging and instruction manual designed by Tamiya, plus a brand-new Tamiya figure and decals for markings and panel lines.
• Markings are included to depict a choice of two F-35Bs at the U.S. base in Iwakuni, Japan.
• Parts are included to recreate ordnance such as AIM-120 air-to-air missiles, plus a missile troley.
• Choose between open and closed canopy parts.
• Aircraft and ordnance parts are a product of Italeri.
Our Price: $51.99
AH-64A ANG South Carolina
Description:
Our Price: $56.99
ACADEMY 1/72 TYPHOON MK.IB
Description:
The Hawker Typhoon is a British, single-seat, single-engine, metal, semi-shell fighter attack in the low wing structure of the Second World War. Designed in accordance with the requirements set by the British Ministry of Defense in the specification F.18 / 37 of 1937, by the famous designer Sydney Camm. The flight of the prototype took place on February 24, 1940, and the machine entered mass production in 1941. The planes were powered by three variants of the Napier Saber Mk.II engine, ranging from 2180KM to 2260KM. There were five versions of this aircraft. The first two are the fighter F.Mk.IA and F.Mk.Ib, which differ mainly in their on-board weapons. AI Mk.IV and Hawker Typhoon FR Mk IB radar fighter - reconnaissance version. Having dealt with initial design problems, especially engine flaws, the Hawker Typhoon also had great success against V1 shells and German tanks during the fighting in Normandy. In total, over 3,300 copies were built. Technical data (Typhoon F.Mk.IB version): length: 9.73 m, wingspan: 12.67 m, height: 4.66 m, maximum speed: 663 km / h, climb speed: 13.59 m / s, maximum range: 821 km, maximum ceiling 10700 m, armament: fixed - 4 Hispano Mk. II 20mm cannons, suspended - up to 908 kg of bombs, 8 RP-3 missiles.
.jpg)
Our Price: $14.89
LINDBERG 1/72 Lindberg Vietnam Era Fighters 2 Pack Scale Mo
Description:
One kit each F4G Phantom and A4D Skyhawk plastic model kits.
.jpg)
Our Price: $28.79
ATLANTIS 1/67 B-26 Invader Medium Bomber USAF
Description:
1/67 Scale. This kit comes from the old Monogram tooling. Comes molded in silver with clear parts and landing gear. Features updated decal sheet and artwork. Skill level 2. Officially licensed with Boeing. During World War II, the B-26 (formerly A-26) was developed by the Douglas Aircraft Company to fill the need for a modern attack plane. It was named the Invader and was the fastest attack bomber of its day. Combining speed, heavy fire-power and bomb capacity, it served well as a straight bomber, nightfighter, skip bomber or as a strafing and attack plane. This model of the B-26 carried eighteen .50 cal. machine guns and 6 rockets in addition to the regular bomb load within the fuselage. The gun turrets in the fuselage were remotely controlled and were aimed by a gunner using a periscope-like sighting mechanism.The Invader had a wingspan of 70 feet and was 50 feet 9 inches long. Cruising speed was in the 300 mph class. Power was supplied by two 18 cylinder, double-row Pratt and Whitney radial engines. Normal crew consisted of 3 men.
Measures 9 inches long with a wingspan of 12.5 inches
39 parts
Our Price: $19.99
- Page 12 of 13 | 151 Total Products