Orders Only: 1-800-723-5937 Information: 1-406-259-9004
Hours: Mon - Sat 10-6 MST
INCLUDES
Six hinges
SPECIFICATIONS
5/8" x 1-1/8" total unfolded length
Nylon construction w/steel hinge pin
15 hinges
5/8"x1-1/8" total unfolded length
FEATURES
Nylon construction w/steel hinge pin
INCLUDES
Six hinges
SPECIFICATIONS
7/16"x1-1/8" total unfolded length
FEATURES
Nylon construction w/steel hinge pin
INCLUDES
15 hinges
SPECIFICATIONS
7/16"x1-1/8" total unfolded length
This is a package of fifteen 1/2A hinge points fron Robart. This hinge installs by drilling a 1/8" hole and inserting the hinge with a drop of glue. No slotting is needed! To make sure the hole you drill is centered use Robart's Hinge Point Drill Jig (ROBR1319). This hinge is suitable for most small aircraft applications and detail work on scale models, such as doors.
This is a Package of Fifteen Steel Pin Hinge Points from Robart. These hinges will install by drilling a 1/8" hole and inserting the hinge with a bit of glue.
FEATURES:
For Heavy Duty Applications like Pattern or Aerobatic Aircraft.
INCLUDES:
Fifteen Steel Pin Hinge Points
This is a package of 6 Super Hinge Points from Robart. These hinges are for 1/4 scale and other large scale uses. These install by drilling a 3/16" hole and inserting the hinge with a drop of glue.
This is a Package of Fifteen Steel Pin Hinge Points from Robart. These hinges will install by drilling a 3/16" hole and inserting the hinge with a bit of glue.
These pockets, when used with hinge points, allow modelers to easily take apart
hinged surfaces for repairs or during construction for painting. Allows for
worn hinges to be replaced in seconds. They have the same simple installation
as hinge points and fasten with a strong, secure set screw. 15 per pkg.
This Is a Hinge Point Drill Jig from Robart.
FEATURES:
Guides and drills mounting holes for hinge points.
Adjustable for all control surfaces.
It's made of hardened steel.
Incorporates removable drill bushings.
Instructions provided.
INCLUDES:
One Drill Jig
Two Bushings
REQUIRES:
Drill (1/8" and/or 3/16")
SPECS:
Bushing Diameters: 1/8" and 3/16"