Orders Only: 1-800-723-5937 Information: 1-406-259-9004
Hours: Mon - Sat 10-6 MST
Simply plug these handy switches into an open channel of your R/C receiver for complete control of your ignition kill, magneto shut off, lights or anything you can dream up! The RC-100X consumes very low power, and has a high current carrying capacity (Capable of 5 amps at 30V!). The swictch is configurable in either normally open or normally closed configuration.
Universal ESC Control Switch
This switch is designed to provide temporary control of the ESC between flying sessions. Without removing the battery pack it cuts off power from the controller's BEC circuitry to the receiver. This will prevent accidental motor runs due to interference or unintentional transmitter control while the plane is in the pits area. The simple plug and play design is compatible with all ESCs.
Note: this switch does not disconnect the battery from the ESC. The battery must be removed after flying session to prevent depletion of the battery.
KWIK SWITCH /CHARGING JACK BY DU-BRO. Enables customer to charge RECEIVER battery from the outside of the plane.
INCLUDES
2-Screws (8-32x1/4") 1-Instruction Sheet
1-Switch Cap (black plastic)
1-Push Rod
1-Nylon Rod Guide (hex cap) 4x11mm
1-Quick Switch Mount/Base Plate (one of each)
1-Set Screw (8-32)
1-Allen Wrench .
FEATURES
Pre-molded black plastic (mount and base plate)
Push rod is metal with black plastic cap and a (3mm) threaded end length.
Universal, FITS ALL RADIO SYSTEMS
Maxx Products added a 3-LED on-board battery checker to their best selling Soft Mount One-Piece Charge Switch. The three LEDs - green, yellow, & red - monitor the status of Rx pack under actual load. It is compatible with 7.4 volt flight systems. Mounting cut-off area for this switch is 1.3" x 0.5".
Plug for Hitec/JR/Airt. Z
Spektrum 3-Wire Switch Harness
LED Switch for Hitec/JR/Airt. Z
Maxx Products added a 3-LED on-board battery checker to their best selling Soft Mount One-Piece Charge Switch. The three LEDs - green, yellow, and red - monitor the status of Rx pack under actual load. It is compatible with both 4.8V and 6V flight systems. Mounting cut-off area for this switch is 1.3" x 0.5".
"Screwless" switch mount, doesn't use any screws through the fuselage of the aircraft to mount.
MPI Soft Mount One-Piece Charge Switch for Spektrum, HiTec, Jr systems
Heavy duty switch and wires
Sturdy one piece design
Easy installation and operation
Built in redundancy
DSC compatable
Heavy duty switch with gold plated Futaba style ends.
Maxx Products added a 3-LED on-board battery checker to their best selling Soft Mount One-Piece Charge Switch. The three LEDs - green, yellow, & red - monitor the status of Rx pack under actual load. It is compatible with both 4.8V and 6V flight systems.
Mounting cut-off area for this switch is 1.3" x 0.5".