Orders Only: 1-800-723-5937 Information: 1-406-259-9004
Hours: Mon - Sat 10-6 MST
This is the EC3 Charge Lead with Wire 12" and Jacks.
This is the set of two Dynamite JST Female Connectors with Lead.
This is the Dynamite XH Balance Extension, 9": 6S
Maxx Products added a 3-LED on-board battery checker to their best selling Soft Mount One-Piece Charge Switch. The three LEDs - green, yellow, & red - monitor the status of Rx pack under actual load. It is compatible with 7.4 volt flight systems. Mounting cut-off area for this switch is 1.3" x 0.5".
Plug for Hitec/JR/Airt. Z
6S JST-XH Balance Extension Lead with high quality soft silicone wire. This wire harness utilizes standard JST-XH balance connections used on Venom batteries and many other battery brands. Use this lead to extend the battery balance connection as needed including when utilizing a LiPo safety sack or similar device. Measuring 200mm or roughly 8 inches this lead gives you the extra length needed.
This adapter is used to connect a power supply with 4mm female bullets to a charger with an IC3 Device input connector.
Racer's Edge offers a safe and convenient way to charge batteries equipped with a Deans connector with any charger utilizing 4mm outputs. The overall length of 300mm (12 inch ) provides adequate distance between battery and charger and also allows for placing the battery in a safety sack while charging.
Use a 2 cell battery with a JST-PH little white 3 pin connector with a charger or other device that has a EC3/IC3 connector.
Also has a "Balance Lead"
Chage lead for batteries with IC5/EC5 connector.