Orders Only: 1-800-723-5937 Information: 1-406-259-9004
Hours: Mon - Sat 10-6 MST
Dubro Control Horns Nylon Large
One right control horn w/4 adjusting holes and 2 mounting holes *
One left control horn w/4 adjusting holes and 2 mounting holes *
*(1-1/8" long {tall})
Two mounting plates w/2 mounting holes (5/8"x1/4")
Four 2-56x5/8" round head screws
Dubro Control Horns Nylon 1/2A (2)
Two control horns w/4 adjusting holes and 2 mounting holes
(3/4" long {tall})
Two mounting plates w/2 mounting holes (3/8"x3/8")
Four 2-56x3/8" round head screws
This is a pair of Sullivan heat treated steel control horns for heavy-duty applications, like split elevators or pull-pull systems.
This Package Includes:
(2) 1-1/8" control horns - These have a "L" shaped cross-section and have 4 holes for mounting the clevis at the top of the horn.
(4) Control horn mounting screws - These are 2-56 x 3/4" screws. They use a flat head screwdriver to tighten/loosen.
(4) Plastic washers
(2) Control horn mounting plates - These are made of nylon.
(2) Nylon Clevis points - This piece mounts to the control horn. They have a hole in the top where the clevis pin goes through. They secure to the control horn by using a small piece of 1/32" music wire (or a paper clip, neither are included)
(2) Nylon washers - These secure the clevis point to the control horn
Dubro 90° Nylon Bellcrank Assembly
FEATURES:
Nylon, brass, & steel construction
INCLUDES:
Two 90° bellcrank control horns
Two brass bushings (for control horns to pivot on)
Two 4-40x3/4" round head slotted screw
Two 4-40 nuts
Two flat washers
Two split lock washers
This Sullivan steel control horn features rigidity and high strength that help eliminate flexing -- excellent for ball joints and pull-pull systems.
The mounting plate, bushing and pivot are made of glass-filled nylon.
Includes:
1- steel control horn
2- clevis pivot, clevis bushing, nylon washer and mounting plate all made of glass filled nylon.
2- 2-56 x 3/4" machine screws.
Approximately 9/16" tall
3mm thread
Use the MKD or CHS Ball Bearing clevises
Approximately 9/16" tall
3mm thread
For use with the MKD and CHS Ball Bearing Clevises
CARBON FIBER
CARBON FIBER
CARBON FIBER