Orders Only: 1-800-723-5937 Information: 1-406-259-9004
Hours: Mon - Sat 10-6 MST
They're Back! But Better! The CENTRAL HOBBIES 5/32" diameter Fixed Gear Axles are back. With the same specifications as the original only made from Titanium. Stronger and just as light! Two grooves to allow for different wheel widths up to 3/4 inch (19mm.) The inner grove is for wheels up to .65 inches (16mm.) At the attachment end is a 3/8 inch hex for a box end wrench. The mounting screw is 4-40 X 1/2 inch Stainless Steel with a matching SS washer and uses a 1/16 inch allen wrench.
Axles Diameter: 5/32"
Weight: Approximately 0.22oz (94gr) per pair
Includes:
2 Titanium Axles (5/32" Diameter)
4 Stainless Steel washers (approximately .025 inch thick)
2 4-40 X 1/2 inch Stainless Steel screws with SS washers
4 E-Clips (2 for Spares!)
Light weight Aluminum axles for 3/16" wire gear or retracts with 3/16" struts.
2 grooves in axle is to accommodate different thickness wheels.
Includes:
2 - axles
2 - set screws
4 - E-clips (2 are spares)
These are 1/8"x1.25" Axle Shafts.
FEATURES
Zinc plated spring steel construction.
INCLUDES
Two axle shafts
Two 1/4"nylon lock nuts
REQUIREMENTS
Minimal mechanical knowledge
7/16" wrench for the nuts
3/8" wrench for the axle
SPECIFICATIONS
Length: 1.25" (axle) .325 (thread) 1.7" (total length)
Diameter: 1/8" (axle) 1/4"(thread)
COMMENTS
Bolts to any Dural landing gear with a 1/4" hole.
FEATURES:
Spring steel construction
INCLUDES:
Two axles with lock nuts
SPECIFICATIONS:
Length: 47.3mm (1-7/8") overall end to end
31.8mm (1-1/4") axle length
12.6mm (1/2") thread length
Diameter: 4mm (5/32") axle dia.
7.9mm (11/32") thread dia.
NOTES:
Nut uses a 1/2" wrench
These rugged spring steel axle shafts can take those hard landings and spring right back into shape. Made to go on aluminum landing gear. It is easily adjusted by screwing the threaded end of the axle
into the bushing.
These are 3/16"x2" Axle Shafts.
FEATURES
Zinc plated spring steel construction
INCLUDES
Two axle shafts
Two 5/16"nylon lock nuts
REQUIREMENTS
Minimal mechanical knowledge
1/2" wrench for the nuts
7/16" wrench for the axles
SPECIFICATIONS
Length: 2" (axle) .4" (thread) 2.6" (total length)
Diameter: 3/16" (axle) 5/16"(thread)
These are 1/4"x3.375" Axle Shafts.
FEATURES
Zinc plated spring steel construction.
INCLUDES
Two axle shafts
Two 7/16" Nylon lock nuts
REQUIREMENTS
5/8" wrench for the nuts
9/16" wrench for the axle
SPECIFICATIONS
Length: 3.375" (axle) .5 (thread) 4.125" (total length)
Diameter: 1/48" (axle) 7/16" (thread)
COMMENTS
Bolts to any Dural landing gear with a 7/16" hole.