Orders Only: 1-800-723-5937 Information: 1-406-259-9004
Hours: Mon - Sat 10-6 MST
A combination clunk-type weight and fuel filter.
Made of sintered bronze to provide the ultimate in fuel filtration.
Can be used with gasoline or glow fuel.
Designed to fit all clunk tanks.
One Tank Filter.
2 per package
Fits medium fuel line
For use with both Glow and Gas
This is Sullivan's "Crap Trap" Screen-Type Fuel Filter. Can be used with glow and petroleum fuels. This is Basically a Very Nice "In-Line" Double-Screen Fuel Filter.
Two Screens for Maximum Filtration of Small Particles.
Clear See Through Barrel.
Fits Standard Size Fuel Line.
Designed For Glow, Gasoline, and Diesel Fuels.
One Double-Screen In-Line Fuel Filter.
Large particles are trapped out of the way in the corners of the front filter, small particles fall into a similar trap at the rear filter. You can watch it work in its see-through heat resistant Teflon barrel. This filter fits between the tank and engine.
This Is the Large Size Double Screen Premium "Crap Trap" Fuel Filter by Sullivan.
For use between fuel supply and model fuel tank.
Fuel flows first through a 100 mesh Monel screen, then through a
120 mesh stainless steel screen for increased filtering capacity
to minimum particle sizes.
Clear barrel and aluminum ends.
Easily cleaned by backflushing with fresh fuel or solvent.
Designed for glow, gasoline, and diesel fuels.
One Large Size Double Screen Fuel Filter
For 1/8" & 5/32" ID Tubing
For all YS 2-cycle and FZ series 4-cycle AIRPLANE engines.
Not for Helicopter engines.
This is Sullivan's Aluminum Nipple, designed to fit in all Sullivan Fuel Tanks.
It can be used for an extra fill or pressure port.
Will accept standard and large fuel tubing.
This will also work with bladder systems.
This is Sullivan's Aluminum Stopper Assembly for All Fuels. This stopper fits into both Sullivan and Dubro fuel tanks, and is safe for either Glow or Gas Fuels.
Designed for High pressure, Racing, or Bladder type tanks.
It includes both Glow (white) and Gas/Diesel (black) stoppers with 1/8" and 3/16" brass stoppers.
Red aluminum construction.
Red Anodized Aluminum Neck Cap and Anodized Aluminum Washer, threaded for the included 4-40x1" cap head screw
Two each of 1/8" and 3/16" brass tubing 3-1/2" & 3" long respectively
One White Glow fuel Stopper
One Black Gas/Diesel/Smoke oil Stopper
One fuel clunk
This is Sullivan's Standard Replacement Stopper Assembly.
Contains full stopper parts for glow fuel (a special rubber stopper and two nylon compression spacers, 3 pieces of brass tubing, a special special self tab screw and a CW 25 clunk weight).
Fits all Sullivan tanks.
One Standard Replacement Stopper Assembly
This is a Large Capacity Gas Stopper conversion kit for Sullivan Fuel Tanks.More Info
Brass pressure fitting.
Easily mounts anywhere on the muffler by drilling a hole and bolting it or taping a smaller hole.
Tapping instructions provided.
(1) Bolt-On Pressure Fitting